Vermeil and Gold Plating Specs for inside the Atelier
Vermeil means a gold layer of at least 2.5 microns over sterling silver, and the US market reads that number as a material claim rather than a finish note. Below 2.5 microns the piece is gold-plated, not vermeil, and the word cannot be used, quoted at USD 60-336 per piece in retail box with care card.
We run 3 microns on inside the Atelier for accounts that publish the claim, with a palladium strike layer so wear-through reads white and not yellow. Thickness is logged per lot and appears on the GRA report batch sheet, and the Vermeil Upgrade quote for it sits at USD 60-336.
The cost difference is real: the USD 60-336 band moves up roughly sixty percent against rhodium-finished silver, and the retail price has to carry that or the margin disappears in the second season when the plating shows wear.
Why the Vermeil Upgrade Quote Looks Cheap Until It Lands
Two buyers ordered the same inside the Atelier in the same month. One paid 9% less and absorbed 23 rejects out of 100 pieces; the other paid our quote and shipped clean. The difference was prong geometry, and it was measurable on both benches, priced at USD 60-336 for the 100-piece Vermeil Upgrade run.
Nothing in that rejection was exotic. At USD 60-336 per piece and 100 pieces on the order, a prong geometry rate of two percent is a costing error rather than a quality mystery.
Cost of the fix was about 22 seconds per piece. On 100 pieces that is a few hours at the bench and the whole claim file disappears, on a 100-piece Vermeil Upgrade order at USD 60-336.
What Fails First on inside the Atelier
prong geometry
A prong that grips the girdle instead of the pavilion survives the showroom and fails the third ultrasonic clean. The seat has to be cut to the pavilion angle before the prongs close, priced at USD 60-336 for the 100-piece Vermeil Upgrade run.
Our countermeasure is a gauge and a written limit. It adds about 22 seconds per piece and removes the defect from the run rather than from the carton, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
rhodium burn-off
A 0.05 micron rhodium layer reads white in the tray and shows yellow at the shank in six months of daily wear. Thickness, not bath chemistry, is the variable that matters, which is USD 60-336 on the Vermeil Upgrade schedule.
In a 100-piece run this typically shows on 14 of pieces. Catching it means measuring stone retention after a 40-cycle wear test at the tray level, not inspecting the finished carton, which the Vermeil Upgrade file records at USD 60-336 in retail box with care card.
size-step drift
A run gauged at size 6 and estimated elsewhere ships a size 8 that measures 7.75. The mismatch shows up as a resize queue two weeks after launch, certified GRA report and packed retail box with care card at 100 pieces.
The commercial effect is a return shipment plus a resize labor claim, typically USD 9-14 per piece. Buyers who have seen it once put it in the purchase order; buyers who have not usually discover it on the first return, on a 100-piece Vermeil Upgrade order at USD 60-336.
What a USD 60-336 Quote Hides
The cost of a inside the Atelier in the USD 60-336 band splits roughly as below. The line buyers challenge most is labor, and it is the line that decides whether the piece survives a season.
| Cost line | Share | What moves it |
|---|---|---|
| Base metal or alloy for inside the Atelier | 34% | Alloy choice and casting yield |
| Stone or melee for inside the Atelier | 25% | Sieve range and lot batching |
| Setting and finishing labor for inside the Atelier | 22% | Jig design and bench minutes |
| Plating, polish and QC for inside the Atelier | 15% | Per-tray versus per-piece checks |
| Packaging for inside the Atelier | 4% | retail box with care card |
If a supplier will not break out the five lines above, the number you are comparing is not a price. It is a total that somebody else assembled from assumptions, with GRA report and retail box with care card stated on the same sheet, which is how the Vermeil Upgrade account reads it at USD 60-336.
The Measurements Behind a USD 60-336 Quote
Four numbers separate a 100-piece run that clears inspection from one that generates a credit note. None of them appears on the sample photo, shipped as retail box with care card and certified GRA report.
| Spec point | Common trade output | HOLYCOME standard | Cost if missed |
|---|---|---|---|
| Plating thickness | Nominal only | 0.20 micron rhodium logged per lot, 3 microns on vermeil | Wear-through inside one season |
| Surface porosity after polish | Seen after plating | Cast porosity checked before plating, rejects pulled at that stage | Plating blister six weeks later |
| Stone colour consistency | Graded by eye under D65 | Colour matched to a retained master stone, per tray | Repeat colour complaint in the same SKU |
| Sizing drift across the run | Not measured | Go/no-go gauge on every size, drift held under 0.15 mm | Resize queue and reship cost |
None of these are premium features. They cost seconds per piece and they remove the reason a buyer has to inspect twice, which is USD 60-336 on the Vermeil Upgrade schedule.
MOQ, Samples and the Balance
The commercial frame is short enough to state in full. Minimum order is 50 pieces per design, and mixed designs travel in one shipment, so a 100-piece Vermeil Upgrade order can carry three or four models without a separate setup charge. Sample pieces leave in 3-5 days when the components are in stock, and a new model adds about twenty days before the first article exists, and the Vermeil Upgrade quote for it sits at USD 60-336.
Payment is 30 percent with the order and 70 percent against the bill of lading, with the balance window stated on the invoice rather than agreed by message. Prices quoted at USD 60-336 are FOB Guangzhou or Shenzhen; DDP is quoted separately because the duty line moves with the tariff schedule and not with our cost.
Packing follows the retail box with care card format at 100 pieces to the carton, and the packing list carries SKU, size and stone size so receiving can count without opening every box. Private-label cartons add three days for the print run and must be approved before the first bulk order, not after it, and the Vermeil Upgrade quote for it sits at USD 60-336.
Certification is GRA report for the lots that carry it, with a batch report and per-piece measurement of stone retention after a 40-cycle wear test for the lots below the threshold. The document set travels with the shipping papers, which is what a customs broker asks for at the port rather than after clearance, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
A rejected tray is settled inside the same order cycle against the retained reference piece. If the difference sits on our retained sample we replace or credit; if it appeared in transit we split the assay cost and file with the carrier, and that rule is written on the order before the deposit clears, quoted at USD 60-336 per piece in retail box with care card.
Carton Cube, Duty and the Freight Line That Surprises Buyers
A buyer who understands this about inside the Atelier negotiates differently, and usually negotiates less, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
We run this check per tray rather than per carton because the defect that matters on inside the Atelier is the one that repeats. A single odd piece is noise; a pattern across one tray is a process problem and it will be in every tray made after it, which is USD 60-336 on the Vermeil Upgrade schedule.
The report the buyer receives states the count per tray, the measured average and the outlier count for inside the Atelier. It is deliberately unglamorous, and it is the document that settles most disputes before they start, the figure being USD 60-336 for a 100-piece run.
Alloy, Karat and the Cost of a Color Change
For inside the Atelier at this price band, the honest answer is a range rather than a point, and the range has a reason, on a 100-piece Vermeil Upgrade order at USD 60-336.
The buyers who get the most out of inside the Atelier treat the first order as a measurement, not as a purchase. They buy a small run, measure the four numbers that matter, and then commit, which is how the Vermeil Upgrade account reads it at USD 60-336.
We support it directly on inside the Atelier: a 50-piece test run per design, the same gauge standard as a bulk order, and the same retained tray. Small does not have to mean loose, which is how the Vermeil Upgrade account reads it at USD 60-336.
The Dock Check on inside the Atelier
We ship from Guangzhou or Shenzhen and pick the port on the carrier rate, not on habit. GRA report travels with the shipping documents, the figure being USD 60-336 for a 100-piece run.
DDP removes the duty invoice that arrives after the carton clears, which matters on a first Vermeil Upgrade order at USD 60-336.
Three steps at the dock: count against the packing list, weigh a sample tray, measure ten pieces. None needs a lab, which the Vermeil Upgrade file records at USD 60-336 in retail box with care card.
From Spec to retail box with care card
The calendar below is what we quote on a 100-piece Vermeil Upgrade run of inside the Atelier. It starts when the spec is signed, not when the deposit clears, and at USD 60-336 for 100 pieces that is the number the buyer signs.
- Sign the drawing at 1:1 scale with a millimetre grid, not a phone render.
- Cut the model in wax or resin and photograph it on the gauge before metal is committed.
- Cast the first article, set the stones and finish it exactly as bulk will be finished.
- Send the first article for approval with the weight and the stone measurements stated.
- Run the balance of the order in 25-30 days, holding the approved article as the reference.
- Ship with the approved article photographed beside a production piece from the same tray.
A first order of 50 pieces is a measurement, not a purchase. It tells you what stone retention after a 40-cycle wear test looks like from this bench, and the Vermeil Upgrade quote for it sits at USD 60-336.
A 100-Piece Test Run
At 100 pieces inside retail box with care card, the first order reads sell-through without betting the season on one model, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
Buyers who run that measurement before committing a season usually keep the supplier. Buyers who skip it usually pay twice for the same lesson, certified GRA report and packed retail box with care card at 100 pieces, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
Frequently Asked Questions
How long does a reorder of the same inside the Atelier take?
With the model, the gauge set and the signed spec already in our system, a repeat is 12-15 days; a first run is 3-5 days for a stock-component sample and about 20 days when a new model is needed, which the Vermeil Upgrade file records at USD 60-336 in retail box with care card.
What finish do you use, and how thick is it?
Rhodium at 0.20 micron minimum on white inside the Atelier, with a palladium strike layer so wear-through reads white rather than yellow. Vermeil runs at 3 microns over sterling and is logged per lot, and 100 pieces leaves Wuzhou in retail box with care card at USD 60-336.
How is inside the Atelier packed for retail box with care card?
Every unit goes into a foam-backed pouch, then the retail box with care card, then the outer carton at 100 pieces. The packing list carries the SKU, the size and the stone size so receiving can check without opening every box, which is how the Vermeil Upgrade account reads it at USD 60-336.
Can you ship DDP?
DDP is available for US accounts and removes the duty invoice that arrives after the carton clears. FOB Guangzhou or Shenzhen is the default, and most buyers take DDP once and then switch after they see the breakdown, shipped as retail box with care card and certified GRA report.
How long does a reorder of the same inside the Atelier take?
With the model, the gauge set and the signed spec already in our system, a repeat is 12-15 days; a first run is 3-5 days for a stock-component sample and about 20 days when a new model is needed, which the Vermeil Upgrade file records at USD 60-336 in retail box with care card.
Next Step
If you are quoting inside the Atelier against another supplier, send that quote. We will mark the four lines where the numbers diverge and let you decide, the figure being USD 60-336 for a 100-piece run.
The factory behind inside the Atelier here is Wuzhou HengliLai Jewelry Co., Ltd., operating since 2009 in Wuzhou, Guangxi, at roughly 60,000 pieces a month. Reach the export desk at service@holycome.com or +86 18078079070 on WhatsApp, priced at USD 60-336 for the 100-piece Vermeil Upgrade run.
Related reading: Inside the Atelier Amazon FBA Ready: AQL, Tray Checks and What a QC Report Should Say - HOLYCOME Inside the Atelier Made to Order: What the Quote Actually Covers - HOLYCOME
